rammy1500
Supporting Member X2
First off, I only ride the 900 a few times a year. I enjoy taking it out of the garage, pull the choke, turn the key and hit the start button and it fires up. Normally takes a few tries and fires up slow until all 4 cylinders kick in, then I'm off. But recently, it seems it is only running on 3 cylinders until a few trips around the block then all 4 kick in. Well yesterday, same routine, but never fired on all 4. Of course, first though is carbs need cleaned, ugh. So being a nice day, I figured I would dive a little deeper. So checking the spark is easier than removing and cleaning the carbs. Spark on 2 and 3 was non-existent. I repacked the coil with the original and still not firing on all cylinders. Pulled the air filter and shot some cleaner into the airbox, still not running correctly. Was about to push it back into the garage until I had a chance to pull the carbs, but figured to go ahead and swap the ignition coil on 1 and 4 cylinder. Guess what I found? I didn't even notice the crack on the first one I pulled, but did on the second. I paid good money from DB electrical for these coils.
So I know that Dyna sells good coils but does take modifications to get them to fit. I can steal a set off of one of the parts bikes, but those are already 40 years old. So any advice on other brands that you have had luck using?
So I know that Dyna sells good coils but does take modifications to get them to fit. I can steal a set off of one of the parts bikes, but those are already 40 years old. So any advice on other brands that you have had luck using?