ZL600 Fuel Filter

John S

Active Member
Joined
May 14, 2013
Messages
25
Reaction score
5
Has anyone installed an inline fuel filter on a ZL600? I have a 97 ZL600, and just had the carbs redone. When reinstalling everything, I heard something rattling around in the tank - turned out to be the filter element that is part of the fuel tap that sits inside the tank. I used some fuel resistant gasket dressing to reattach it where it belongs, but felt it wouldn't be a bad idea to add an in-line filter. I got a small plastic one (not overly thrilled with it), but didn't find a good place to nest it. Right now it's laying down sideways above carb #1. But from here, the fuel line makes a hard 90 to attach to the fuel tap, and it tends to get pinched to the point that fuel stops flowing. I added a little extra (maybe an inch or two) to the fuel line to make tank removal a bit easier - but that seems to be making it more prone to getting kinked.
I've searched the forums here, but so far haven't found any good posts on this for the ZL600. I saw some recommendations for a Pingle filter - but not sure if it will fit anywhere on this bike. I did find some fancy glass filters on line - and cautionary tales here to avoid them (since glass can break, and leaking fuel could cause a fire).
Any advice on a better filter, location, and fuel line routing?
 
I have used fuel filters that have a 90 degree inlet/outlet design. Don't remember who makes them but they are out there.
 
I replaced the original fuel petcock with a new manual on/off fuel petcock. Do you still have the original air box? If not then I ran a fuel line through the small box below the seat with an inline fuel filter to the carbs from there. Everything is nicely tucked away out of sight. Been running great from almost 2 years now.
 
Except for maintenance items, the bike is all original, and unmodified. The inline fuel filter is the only part that's not "original design". Part of me wished the air box wasn't there when I was trying to reinstall the carburetors, but it's all back together now!
 
Wish I would have been able to pick up some of those 90° filters a while back but I was shopping locally. The 90° cone filters are nice and compact.
 
Trouble is there is so little room under the petrol tank, there are some very small in-line metal/ glass-type filters I have seen, can't recall where though!
 
Back
Top