Cable Lube?

ZLrider

Senior Member
Joined
Jun 3, 2009
Messages
1,217
Reaction score
113
My clutch seems a little sticky. Doesn't feel quite right. Was just wondering if there is an easy way to lube it and what you guys are using. Feel free to recommend gadgets if you know something that works well, or special lube. I'd also like to know what type of common spray lubes would work and the easiest way to direct the stream from the little bitty straw into where it needs to go.

Think I lubed this last when had the carbs off by shooting WD40 into it until it ran out the bottom, followed by something I had on hand, some sort of spray oil/lube. Don't remember what it was, but if it needs it again after only a few miles it obviously didn't do the job too well.
 
Hm, it says chain and cable lube. I have a can of chain lube from when I had bikes with chains. Would that be OK to use on cables you think? Also is the gizmo worth having? I guess you'd need to get the barrel part of the cable out of the handle to use it. I was sorta hoping for a way to lube cables without taking anything apart. Wishful thinking maybe.
 
I use a tool as well and wd-40.
I think there is a pic in the manual showing cable poked thru the corner of a baggie that gets rubber band to cable housing then put some oil in the baggie and let gravity do it's thing.
 
I've seen a Kawasaki cable inner wear thru the plastic lining and into the steel elbow. It's the sharpest bend and the cable digs into the inner radius with each pull especially when it's stiff. At that point, it needs replacing. I like using synthetic motor or gearbox oil to loosen up a sticky clutch cable but never needed lube on any thing I've owned. A dry lube like Dri Slide will cause problems over time.
 
Thanks for all the good ideas. Not sure I'm onboard with the WD40 though. That stuff is great to get stuff loose if it's not rusty, but it's so thin seems like it wouldn't last for long. I like the idea of lithium grease, but isn't it too thick to push through the entire cable? Speaking of cables, I have a new cable around here somewhere. Not sure which one. I just now remembered that when I got rid of the KZ650 I ended up keeping that one part after finding it was also correct for the ZL. I'm going to go find it after the suggestion that the cable could be nearing the end of it's life. Clutch is still working fine, it just doesn't feel quite right.
 
Back
Top